A Bead Winder Unit is used to wind the O.D. curf generated from scarfing the weld seam from Tube & Pipe.
The unit will have the mounting assembly designed to retro-fit in your available window although some modifications may be required to existing hardware.
The unit is equipped with an air motor driven spindle with a fixed back plate which has four pilot pins to accept a hinged front plate. The front or operator side hinged plate has four tubes welded in place to correspond to the pins in the fixed back plate.
The front plate has two steel rod handles to allow removal and unloading of the accumulated scarf. The tension of the winding operation is set by increasing or decreasing the compressed air pressure driving the motor and this acts in place of a clutch.
This unit consists of a custom base, the mechanicals, a solenoid piloted valve, a filter, a regulator, a lubricator and will be furnished pre-piped but not wired. Power source, switches and connection are to be customer provided.
Spare Parts for Bead Winder include, but are not limited to:
- Bead Winder Arbor Shaft
- Bead Winder Spindle Rods